Genuine Transmitter and JR Tx/Rx Charger 150/150 mA (DSX9) Modeller Support. JR Propo Product Manuals to observe not only the instructions and precautions in this manual, but also the Please be sure to purchase a 'radio control insurance policy'. JR Propo Transmitters. JR radio systems are best known by passionate RC modelers for their precise response, intuitive programming and superior ergonomics. You really can 'Feel the Difference'. JR are also innovators in servo, gyro and receiver technology.
• 7 CHANNEL 2.4GHz DUAL MODULATION SPECTRUM SYSTEM 7 CHANNEL 2.4GHz DUAL MODULATION SPECTRUM SYSTEM Operation Manual Warranty Repair Card Included Prior to use, please read this manual thoroughly. Keep this manual in a convenient place for quick and easy reference. • Thank you for your purchase. As this proportional radio system is a very delicate instrument which is subject to use under vibration and other severe conditions, please read this manual thoroughly before use for your safety. Make sure to especially confirm and follow the GENERAL NOTES &. • GENERAL NOTES & PRECAUTIONS for Safety Make sure to follow the following.
About the Proportional System DANGER Please understand that we cannot be responsible for any accident, Out-of-control and danger can be caused. Failure, etc. That may occur from modification of this product, use of DO NOT use the product on rainy days since it may cause non-genuine parts, natural disaster, or non-observance of the precau- malfunction if water gets inside the transmitter/receiver. • Rechargeable Battery and Battery Charger DO NOT scratch or tear off the insulating tube, the lead wire, and the connector.
Abide by the following to prevent potential leakage, explo- DO NOT use the battery if a scratch is left on the insulat- sion, heat generation, and fire ing tube, lead wire, and connector, or if the insulating is damaged. • Specifications of the Set Transmitter Part No. XG7(NET-K337G) Operation 7 channels, Computer mixing system system Transmit 2.4GHz band, frequency FH-SS (Frequency hopping system spectrum diffusion) Power supply Dedicated nickel metal-hydride battery 8H1500(1500mA) Consumption 250mA current Neutral 1.5m s Battery Charger Part No. • Transmitter Names and functions of parts Antenna Trainer (Rocker) Switch Hovering Pitch Trim (FOR HELI) Neck Strap Eyelet Flap lever Switch (FOR AIRPLANE) Carrying Bar Rudder Dual Rate Switch Throttle Hold Switch (FOR HELI) Mixing Switch (FOR AIRPLANE) Hovering Throttle Trim (FOR HELI) AUX 2 Lever Switch (FOR AIRPLANE) Flight Mode Switch (FOR HELI) Flap Mixing Switch (FOR AIRPLANE) • Names and functions of parts on the rear side Status LED Trainer Jack Battery Charge Jack Battery Cover When changing the battery, press this cover down to open it. When closing the rear cover, take care not to catch the lead wires between the cover and the case. • How to Set Bind In the situation where this transmitter and receivers are being used after changing the model, and in the situation CAUTION where a new receiver is being used, binding (pairing) must be carried out otherwise the receiver will not operate. 